Monte Carlo Fan Company AC-552 Installation Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
© 2013 Monte Carlo Fan Company
3/8/2013
Light bulbs and glass installation
Install 2 x 60 watt candelabra base bulbs, Bulbs included.
WARNING: Over lamping the fan will result in the fan lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off the wall switch, breaker,or by
remote. Replace bulbs with the correct wattage bulbs, turn
the power on.
Caution: Do not replace bulb until it cools down.
Remove finial, final cap and nut from light fixture. Raise glass
in order to guide pull chains through appropriate holes in
glass, aligning threaded rod on light fixture with hole in
middle of the glass and push up gently allowing threaded rod
to come through hole. (Noted: Be sure pull chain for fan
operation does not rub against bulb during operation).
Replace the nut on threaded rod, Tighten the nut but DO
NOT OVERTIGHTEN as glass may crack or break. Align hole
in center of final cap with thread rod, allowing pull chains to
come through appropriate holes in the final cap, and push
up. Thread center pull chain through hole in finial and secure
glass to light fixture by tightening the finial. DO NOT OVER
TIGHTEN the finial as glass may crack or break. (Fig. 13)
Install fan pull chain and light kit pull chain to preassembled
pull chains on fan and light fixture. Pull chains provided.
(Fig. 13)
Forward/Reverse switch setting
Setting the reverse switch in the down position will result in
downward airflow and setting the switch in the up position
will result in upward airflow.
Note: Reverse switch must be set either completely down
or completely up for fan to function. If the reverse switch is
set in the middle position, fan will not operate. (Fig. 14)
Operation and Maintenance
Refer to operation and maintenance on the second page of
parts list.
Glass
Light fixture
Bulbs
Pull chain
Final cap
Nut
Finial
Fig. 13
Reverse switch
Fig.14
Pull chains
Page view 7
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments